Step 3: Disinfecting
Supplies needed:
- A household pot
- Drinking-quality water
Caution: During disinfection with boiling water, prevent the bottle or other parts from touching the side of the pot.
This can cause irreversible product deformation or damage that Philips cannot be held liable for.
1. Fill a household pot with
enough water to cover all parts
and place all parts in the pot.
Let the water boil for 5 minutes.
Make sure the parts do not
touch the side of the pot.
2. Allow the water to cool
down.
3. Gently remove the parts
from the water. Place the
parts on a clean surface/tea
towel or drying rack to air-dry.
4. Store the dry items in
a clean, dry and covered
container.
Using the breast pump
Cushion size
The Philips Avent single/double electric breast pump has a soft, active cushion. It gently stimulates your nipple to trigger milk ow.
The cushion is made of exible silicone, that adapts to up to 99.98 % of women, tting nipple sizes up to 30 mm.
Assembling the breast pump
Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling them, they can be very hot.
To prevent burns, only start assembling the breast pump when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast pump parts and breasts to
prevent contamination. Avoid touching the inside of containers or lids.
Check the breast pump kit parts for wear or damage before use and replace them if necessary.
Note: Correct placement of the cushion, silicone diaphragm and silicone tube is essential for the breast pump to form a
proper vacuum.
5 min.
To Next Page
Loading...
