Philips AZ1852 - Programming Playback Tracks

Tip
Only • and AL can be selected when you play programmed
tracks.
WhenplayCD,ModeshouldbeRepeat/RepeatAll/Shufe.
•
When Mp3, Mode should be Repeat/Repeat Album/Repeat All/ •
Shufe.
Program tracks
You can program a maximum of 20 tracks.
1 In CD/USB mode, at the stop position, press PROG to activate
the program mode.
[PROG] (program) starts to blinks. »
2 For MP3/WMA tracks, press AL-/AL+ to select an album.
3 Press / to select a track number, then press PROG to
conrm.
4 Repeat steps 2 to 3 to program more tracks.
5 Press on the main unit to play the programmed tracks.
During play, [PROG] is displayed. »
To erase the program, in the stop position, press •
.
To review the program, in the stop position, press and hold •
PROG for more than 2 seconds.
General information on cassette recording
Recording is permissible insofar as copyright or other rights of •
third parties are not infringed.
This deck is not suitable for recording on CHROME (IEC II) or •
METAL (IEC IV) type cassettes. For recording you should use
NORMAL type cassettes (IEC I) on which the tabs have not
been broken.