BaseLine Pro with CLI
7
Installation settings
During installation of the phone there are
three switches that need to be set
according to how the local system is
configured. The switches control:
• Message waiting (Message)
This can be set to Reverse Polarity
(RP), High Voltage (HV) or OFF
• Recall type (Recall)
This can be set to Earth Recall (ETH)
or Time Break Recall (TBR)
• Recall timing (TBR)
The timing for TBR can be set to100,
300 or 600 ms
The three switches are located under the
panel containing the memory numbers.
If you have any questions regarding these
switch settings, contact the telephone
manager or your nearest service
representative.
To Next Page
Loading...
