- 15 -
2.3 Software upgrade
For the best user experience, it is highly recommended to use the latest software version available.
Go to: http://www.philips.com/support/
• Select your country, enter the model number and download the latest software version
available from the support page
• Unzip the software and follow the instructions how to upgrade the software on the TV
• The USB flash drive used for software upgrade must be formatted as FAT32 and preferably
empty to avoid an accidental upload of a wrong setting or software
• Preparation:
o Copy the software (autorun.upg) on the root of the USB stick (FA32 formatted) and
do not change the name
• Procedure:
o Start up the TV and wait until it is fully booted up, should take a max of 2min
o Insert the USB stick
o A wizard will automatically appear and start the upgrade to the new SW
o Wait until the process finishes, don’t send any RC command to the TV and do not
unplug the power cord
o After the update is done and the USB stick can be extracted
• It’s required to first upgrade the TV and afterwards to perform the installation
The latest software version and cloning data can be stored on the same USB drive for a 2 in 1 action:
software upgrade and cloning during the instant initial cloning. See chapter ‘Instant Initial Cloning (IIC)’
for more information.
To Next Page
Loading...
