Start therapy
View information
Comfort settings
Undocking
1. From the main menu, turn the control wheel to
Therapy and press.
2. The monitoring screen will be displayed and the
device will start.
Note: You can select the measured parameter to display
on the Monitor Pressure screen. Choose from Leak, RR,
MinVent, or Vte.
Humidification Humidifier settings
1. From the patient screen, highlight Comfort.
The Flex, Ramp, and Rise Time comfort features will be
shown in this menu selection if enabled.
2. Turn wheel to specific setting and press.
3. Turn control wheel to desired option and press to select.
4. To exit, turn control wheel to Back and press.
In provider screen:
1. Turn the control wheel to Info and press.
2. Turn the control wheel to desired option and press to
view the information identified.
3. To exit out of any option, turn the control wheel to
Back and press.
Refer to diagram below. Hold entire unit at each end
and slide release latch to the right.
With device turned off, remove and fill chamber with water.
1. (a) Lift humidifier door until it locks in place. Do not force
door higher than the locked position. (b) Grasp front of
chamber and slide toward you.
2. (a) Gently push tab located inside round opening on top
of chamber. (b) Separate top and bottom of chamber.
3. Fill bottom chamber with distilled water.
4. Observe maximum fill lines located on sides of chamber.
5. Do not overfill.
Reassemble the chamber by placing the hinges on lid over the
two tabs on back of chamber. Close lid until it locks in place
with an audible click. Insert filled chamber into humidifier.
Release latch
Release latch
Release latch
(bottom view)
1. When blower is activated, the humidification icon and
numerical setting will light up on the device.
2. Turn control wheel to adjust humidifier number to the
desired setting (0 to 5) and press. The settings represent
relative humidity levels that will remain consistent throughout
the night even if room temperature changes.
LCD display
screen
Number settings
Humidifier icon
Control wheel/Push button