Philips BTM2056 - FM Radio Functions; FM Tuning, Presets, and RDS

13 EN
5 Listen to FM
radio
Tune to FM radio stations
Note
•
Position the antenna as far as possible from TV, VCR, or
other radiation source.
• Make sure that you have connected and fully extended
the supplied FM antenna.
1 Press FM to select FM tuner mode.
2 Press and hold / for 3 seconds.
» [SEARCH] (search) is displayed.
» The system tunes to an FM station
with strong reception automatically.
3 Repeat step 2 to tune to more stations.
To tune to a station with weak signal:
Press
/ repeatedlyuntilyoundgood
reception.
Program FM radio stations
automatically
Note
•
You can program a maximum of 20 preset FM radio
stations.
In FM tuner mode, press and hold PROG for 3
seconds.
» [AUTO] (auto) is displayed.
» The system stores all the FM radio stations
automatically,andthenbroadcaststherst
preset radio station.
Program FM radio stations
manually
1
In tuner mode, tune to an FM radio station.
2 Press PROG to activate programming
mode.
» [PROG] (program) blinks.
3 Press or repeatedly to select a
channel number.
4 Press PROGagaintoconrm.
5 Repeat steps 1-4 to store other FM
stations.
Note
•
To remove a pre-stored station, store another station
in its place.
Select a preset radio station
In tuner mode, press / or the numeric
buttons to select a preset number.
Show RDS information
RDS (Radio Data System) is a service
that allows FM stations to show additional
information. If you tune to an RDS station, an
RDS icon is displayed.
1 Tune to an RDS station.
2 Press RDS repeatedly to scroll through the
following information (if available):
» Program service
» Program type such as [NEWS] (news),
[SPORT] (sport), [POP M] (pop
music)...
» Radio text message
» Time