1. Reset to defaults：
Plug in, long press “Stop” button quickly, it will display the software version. Then short press the
“Stop” button, it will display “Reset”, and access “STANDBY” in a while. When it displays “--”,
it has been reset to defaults.
2.Check the software version:
Plug in, long press the “STOP” button quickly, it will display the software version.
3.Software-upgrade method:
Copy the updated software(boot.ali and nemo.bin) into USB, insert it into the CD MINI, you
will hear “Do” sound for two times, which means it starts to upgrade. About 40 seconds later, you
will keep hearing “Do” sound which means the upgrade is done. At this time you can unplug the
power and remove the USB. Noted: Should not blackout during the upgrade, otherwise the
machine will crash (it can not start up and the display shows nothing.). After the crash, the only
solution is to remove the FLASH IC (U4, EN25F20), rewrite the software on programmer or
directly replace a new FLASH with effective program.
11. Software upgrade & procedure to restore product setting
To Next Page
Loading...
