Philips CDR 765 - Programming

20
You can program up to thirty tracks to play in a desired
sequence using either the CD Player deck or the CD
Recorder/Player. Individual tracks can be included in the
program more than once, but will count as a track each time
they are included.
1 Press CD-R or CD on the remote control to select a deck.
‹ The message SELECT CDr or SELECT CD will
briefly appear on the display.
2 Press PROGRAM on the remote control to start
programming.
‹
PROG will flash and PROG CDr or
PROG CD will briefly appear on the display.
3 Press a track number with the number keys. For 2-digit
numbers, press the keys in rapid succession.
‹ On the display, the track number appears briefly,
followed by the total programmed tracks and total
program time.
4 Repeat step 2 for all tracks to be programmed.
5 Press STOP or PROGRAM to end programming.
‹ PROG lights continuously.
Note:
- To review the program, press ∞ or § with the deck in
the stop mode.
- To add more tracks to the program, repeat steps 1
through 6 .
- If you try to store more than 30 tracks, FULL appears
on the display
6 Press PLAY to start programmed play.
Clearing a program
1 Press STOP if necessary to stop programmed play.
2 Press STOP again to clear the program.
‹ PROG disappears from the display.
Note: The program is also cleared when you open the disc
tray.
P
R
E
V
.
S
H
U
F
F
L
E
REPE
AT
O
P
E
N
/C
L
O
S
E
D
IS
P
L
A
Y
PROGRAM
C
D
R
C
D
1
2
3
4
5
7
8
0
6
9
y
P
L
A
5
Programming
English
PLAYING