Philips CDR-800 - Unfinalizing CDRW Discs; Erasing CDRW Disc Content

Recording a single track
Recording a single track during playback
1 Make sure the CDR(W) is absolutely free of scratches and
dust particles and insert it into the CD recorder tray.
2 Play your desired track on the CD changer.
3 Press RECORD on the set to enter the recording menu.
➜ REC TR and the tracknumber are displayed.
4 Press either:
YES to start recording,
➜ The arrow lights, RECORD IN PROGRESS is shown, playback
and recording start from the beginning of the selected track
and the actual recording time left starts to count down.
or
NO to continue playback.
Do not forget to finalize!
Recording an entire CD
High speed recording and automatic finalizing of
the current disc
1 Make sure the CDR(W) is absolutely free of scratches and
dust particles and insert it into the CD recorder tray.
2 Select the required disc by pressing CD1, CD2 or CD3.
3 Press COPY CD to enter into the record mode.
➜ The arrow and the YES key start blinking.The remaining
recording time of the CDR(W), the total playing time of the
source CD and RECORD CD1 (or 2, 3) ? are displayed.
4 Press YES to start recording and finalizing.
➜ The arrow lights, RECORD IN PROGRESS and FINALIZE
are shown, high speed recording and finalizing start and
the actual recording time left starts to count down.
Note: If a program was already available before pressing COPY
CD, this will be ignored. PROGRAM goes off and the current disc
will be recorded.After finishing the recording, PROGRAM is
shown and the program is available again.
Do not forget to finalize!
Recording a program
High speed recording and automatic finalizing
(optional) of the current program
1 Make sure the CDR(W) is absolutely free of scratches and
dust particles and insert it into the CD recorder tray.
2 Select and store all desired tracks in the CD changer
memory (see “Programming track numbers”).
3 Press COMPILE CD to enter into the record mode.
➜ The arrow starts blinking.The remaining recording time
of the CDR(W), the total playing time of the program
and REC PROG ? are displayed.
Note: If no program is available and you press COMPILE CD,
you enter immediately into the program menu. Start
programming and return to the record mode by pressing
PROGRAM or COMPILE CD.
4 Press either:
NO to change the program.
➜ PROGRAM starts blinking. Now you can change the
program (see “Programming”) and return to the record
mode by pressing COMPILE CD.
or
YES to confirm recording.
➜ AUTO FINAL ? is displayed.
5 Press either:
YES, if the CDR(W) is to be finalized after recording,
or
NO, if the CDR(W) is not to be finalized after recording.
➜ The arrow lights, RECORD IN PROGRESS is shown, high
speed recording and finalize (if selected) start and the
actual recording time left starts to count down.
Do not forget to finalize!
Internal recording
18
English
xp CDR 800/00 eng.-1.1 18-07-2001 13:54 Pagina 18