Philips CSS2123/05 User Manual

10 EN
8 Product specifications
Note
• Specications and design are subject to change
without notice.
Amplier
• Total output power:
• Europe/Asia Pacic/China/Russia/India:
60W RMS (30% THD)
• Latin America: 48W RMS (10% THD)
• Frequency response: 20 Hz-20 kHz / ±3 dB
• Signal-to-noise ratio: > 65 dB (CCIR) /
(A-weighted)
• Input sensitivity:
• AUX: 600 mV
• Music iLink: 250 mV
Audio
• S/PDIF Digital audio input:
• Coaxial: IEC 60958-3
• Optical: TOSLINK
Main unit
• Power supply: 110-240 V~, 50-60 Hz
• Power consumption: 20 W
• Standby power consumption: ≤ 0.5 W
• Speaker impedance: 4 ohm woofer, 4 ohm tweeter
• Speaker drivers: 25 x 120 mm (1 x 5")
woofer, 38 mm (1.5") tweeter
• Frequency response: 150 Hz-20 kHz
• Dimensions (WxHxD): 708 x 47 x 65 mm
• Weight: 1.03 kg
Subwoofer
• Impedance: 8 ohm
• Speaker drivers: 130 mm (5.25") woofer
• Frequency response: 20 Hz-150 Hz
• Dimensions (WxHxD): 165 x 240 x 295 mm
• Weight: 2.6 kg
• Cable length: 3 m
Remote control batteries
• 1 x CR2025
9 Troubleshooting
Warning
• Risk of electric shock. Never remove the casing
of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, get support at
www.philips.com/support.
Sound
No sound from SoundBar speakers.
• Connect the correct audio cable from your
SoundBar to your TV or other devices.
• On your SoundBar remote control, press the
Source buttons to select the correct audio
input.
• Make sure that the SoundBar is not muted.
Press VOL +/- to restore the sound (see
'Adjust the volume' on page 9).
Distorted sound or echo.
• If you play audio from the TV through the
SoundBar, make sure that the TV is muted.

Philips CSS2123/05 Specifications

General

Brand	Philips
Model	CSS2123/05
Category	Speaker System
Language	English