16
If the timer is deactivated, [ AL1] or [ »
AL2] is displayed.
Repeat alarm
1 When the alarm rings, press
BRIGHTNESS/REP ALM.
The alarm repeats ringing minutes later. »
Tip
You can press • / to adjust the interval to
repeat alarm.
Stop alarm ring
1 When the alarm rings, press the
corresponding ALM 1 or ALM 2.
The alarm stops but the alarm settings »
remain.
View the alarm settings
1 Press ALM 1 or ALM 2.
Adjust display brightness
1 Press BRIGHTNESS/REP ALM
repeatedly to select different levels of
display brightness.
6 Other features
Set the alarm timer
You can set two alarms which go off at different
time.
1 Make sure that you have set the clock
correctly. (See “Get started - Set time
and date”.)
2 Press and hold ALM 1 or ALM 2 for two
seconds.
[AL 1] or [AL 2] begin to blink. »
3 Press SOURCE on the top panel to select
an alarm sound source: DOCK1, DOCK2,
FM tuner, or buzzer.
4 Press ALM 1 or ALM 2.
The hour digits begin to blink. »
5 Press / repeatedly to set the hour.
6 Press ALM 1 or ALM 2 to confirm.
The minute digits begin to blink. »
7 Repeat steps 5-6 to set the minute.
8 Repeat steps 5-6 to select whether to
ring alarm the whole week, on weekdays,
or at weekend.
9 Repeat steps 5-6 to set the alarm volume.
Tip
You can create a playlist in iTunes called •
“PHILIPS” and import it to your iPod/iPhone
as alarm source.
If no playlist is created in the iPod/iPhone or •
there is no song in the playlist, the unit will
wake to songs in the iPod/iPhone.
Activate and deactivate the alarm
timer
1 Press ALM 1 or ALM 2 repeatedly to
activate or deactivate the timer.
If the timer is activated, [ »
AL 1] or [
AL2] is displayed.
EN
To Next Page
Loading...
