13
English
2 Press OK to confirm.
A channel and its frequency appear »
on the display.
3 Press / repeatedly to tune to a
DAB+ radio station.
4 Press OK to confirm.
[DRC] (Dynamic Range Control)
• [DRC 0]: No compensation applied.
• [DRC 1/2]: Medium compensation
applied.
• [DRC 1]: Maximum compensation
applied (the default option
recommended for noisy
environment).
[TUNERRST]
• [YES]: Reset the tuner.
• [NO]: Cancel.
Tip
If no button is pressed within 10 seconds, the menu •
exits.
Show DAB+ information
While listening to DAB+ radio, press INFO
repeatedly to scroll through the following
information (if available):
Dynamic Label Segment (DLS) »
Signal strength »
Program type (PTY) »
Ensemble Name »
Channel and frequency »
Signal error rate »
Bit rate and audio status »
Date »
5 Repeat the above steps to store other
DAB+ stations.
Note
To remove a pre-stored DAB+ radio station, store •
another station in its place.
Listen to a preset DAB+ radio
station
1 In DAB+ mode, press / repeatedly
to select a DAB+ radio station.
2 Press OK to confirm.
Note
If no DAB+ radio station is available, the steps •
mentioned above are invalid.
Use DAB+ menu
1 In DAB+ mode, press and hold MENU to
enter the DAB+ menu.
2 Press / repeatedly to navigate
through the options:
• [MANUAL]: Tune to a specific
channel manually.
• [SCAN]: Perform a wide range of
DAB+ radio search.
• [DRC]: Add or remove a degree of
compensation for the differences in
the dynamic range between radio
stations.
• [TUNERRST]: Reset the tuner.
• [VERSION]: Display software
version.
3 To select an option, press OK.
4 Repeat steps 2-3 if sub-option is available
under one option.
[MANUAL]
1 In DAB+ mode, press MENU repeatedly
until [MANUAL] is displayed.
EN
To Next Page
Loading...
