Philips DCC170/00 - Tape Transport Adjustment Procedure

(3)
Tape Transport
Adiustment
Load
the mirror
tape
(SBC438)
into
the
unit and check
tape transport in PLAY
mode, Check
both
Íorward
and reverse directions. lf
the top
edge of the tape is
curled, remove
the curl by following
the
steps below:
Tape
guide
Tape
FATG
side
view
Tape
hub
A
curled tape
edge
will
not occur
at the bottom
@
of the tape
guide,
as the
tape
is
pushed
up
along a slope.
Check
for
a curled tape
edge at the top
@
of
the tape
guide.
guide
O
lf
a
curled
tape
edge occurs on
FATG
(L)
:
Turn
O
head
height
adjusting
screw
(R)
clockwise
until
the curlis removed.
Curling
(L
side)
Tape
Tape
FATG
side
view
X
Adjustment needed
Tape
hub
FATG
@
lf
a curled tape
edge occurs
on
FATG
(R)
:
Turn
@
head height
adjusting
screw
(R)
counterclockwise
until the curl
a
IS removed.
X
Adjustment
needed
Curling
(R
side)
Tape
Tape
FATG
side
view
Tape hub
FATG
@
When
the relative
positioning
LR
of the tape hub
and tape
head
(tape guides)
is
correct:
(L
/R
both
sides)
Tape
Tape
FATG
side
view
C
No
adjustment
needed
Tape hub
FATG
After completing
the above adjustment, run
the tape both
forward
and backward to check
for
a curled
tape edge. lf it
still occurs, repeat
step
O
or
@.
-
ls
-
pcs
Tg
277
Note:
Since
the
head
arm
has
a
differ
before and after
the
margin.)
slight amount
of
play,
the degree
to
adjustment
screwdriver
is removed.
which the
tape
edge curls will
(Allow
a
sufficient adjustrnent