EasyManua.ls Logo

Philips DCM3065/51 - Set the Sleep Timer; Play from an External Device; Headphone; Product Information

Philips DCM3065/51
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
English
EN
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
1 When the unit is turned on, press SLEEP/
TIMER repeatedly to select a set period of
time (in minutes).
» When sleep timer is activated,
is
displayed.
To deactivate sleep timer
1 Press SLEEP/TIMER repeatedly until [OFF]
(off) is displayed.
» When sleep timer is deactivated,
disappears on the display.
Play from an external device
You can also listen to an external audio device
through this unit.
1 Press MP3 LINK to select the MP3 link
source.
2 Connect the supplied MP3 link cable to:
the MP3 LINK connector (3.5mm) on
the unit.
the headphone connector on an
external device.
3 Start to play the device (see the device's
user manual).
Headphone
Plug headphones (not supplied) into the
connector on the unit to listen through the
headphones.
9 Product
information
Note
Product information is subject to change without prior
notice.
Specications
Amplier
Maximum Output Power 58W RMS
Frequency Response 60 Hz - 16 kHz,
±3 dB
Signal to Noise Ratio >65dBA
MP3 link input 500mv, 20kohm
Tuner
Tuning Range FM: 87.5 - 108 MHz
Tuning grid 50 KHz
FM sensitivity
- Mono
26 dB
Total Harmonic
Distortion
<2%
Signal to Noise Ratio >55 dB
Number of presets 20 (FM)
Speakers
Speaker Impedance 8 ohm
Speaker Driver 2 X 2.5" full range
Sensitivity >82 dB/m/W

Related product manuals