Philips DE5205/00 - Getting Started; Installing the Filter; Positioning the Dehumidifier

7EN
English
Positioning the
dehumidier
To increase the dehumidifying
eectiveness, position the dehumidier
in a location that can draw the most air.
Note
• When the dehumidier is operating,
do not open exterior doors or
windows.
3 Getting started
Installing the lter
Note
• Make sure that the appliance is
unplugged before installing the
lter.
Before using the appliance, remove all
packaging materials from the lter and
place the lter into the appliance as
described as follows.
1 Pull the top part of the rear panel to
remove it from the appliance
(g.c).
2 Take out the HEPA lter and the
pre-lter (g.d).
3 Remove all packaging materials
from the HEPA lter (g.e).
4 Place the HEPA lter into the
dehumidier and then the pre-lter
(g.f).
Note
• Make sure that the HEPA lter and
the pre-lter are properly attached
to the dehumidier.
5 Reattach the rear cover by pressing
the bottom part of the rear cover
onto the appliance rst (1). Then,
gently push the rear cover against
the body of the appliance (2)
(g.g).
6 Wash your hands thoroughly after
installing lters.