Philips DFR9000 - Page 9

2. EEPROM test
Purpose: This test is used to check reading and writing of
data from and to the EEPROM located on the front
board.
3. EEPROM format
Purpose: Format the EEPROM located on the front board
(i.e. load the EEPROM with factory defaults).
MAIN MENU
EEPROM Format
Force modules
to load the
EEPROM with
default values
N
Y
Display shows
“DEFAULT”
Wait 2 seconds
RC “2”
pressed?
MAIN MENU
N
Y
N
Y
Y
read patt. =
written patt.
?
N
write & read back
EEPROM
test pattern
Next address
location
Last
address
location?
Y
N
RC “OK”
pressed?
Display shows
“PASS”
EEPROM Test
Display shows
“FAIL”
RC “1”
pressed?
2-4
www.freeservicemanuals.info
13/10/2016
Published in Heiloo Holland