36
a My cable box has not switched to the other channel number
1 Check whether the cable box is connected and switched on.
2 Check the connection and position of the IR Blaster.
3 If the connection is OK, select:
'test this code again' for a new attempt.
4 Confirm with OK on the remote control.
5 For a new code, select 'No'.
6 Confirm with OK on the remote control.
a My cable box is not displaying the channel number
b On your TV set, select the channel number of the cable box and
check the setting on the screen of the TV.
Problem
Finalize setup
1
Check the settings shown on the screen. If the settings are not
correct, repeat the set-up procedure by selecting 'No, repeat
setup process'. Otherwise, select 'Yes, end setup process'.
2
Confirm with OK .
You will now see a screen with useful information of the GUIDE
Plus+
®
system.
3
Confirm with OK .
You will now see a message confirming the completion of the
GUIDE Plus+
®
system set-up process.
4
Confirm with OK . This completes the set-up process for the
GUIDE Plus+
®
system. The informations will be available within
the next 24 hours.
The GUIDE Plus+
To Next Page
Loading...
