Philips DVP620VR - Rear Panel Connections; Remote Control Functions

Safety Check after Servicing
Examine the area surrounding the repaired location for .
damage or deterioration. Observe that screws, parts, | Chassis or Secondary Conductor
and wires have been returned to their original posi-
tions. Afterwards, do the following tests and confirm : Primary Circuit Terminals
the specified values to verify compliance with safety :
standards.
1. Clearance Distance
When replacing primary circuit components, confirm
specified clearance distance (d) and (d’) between sol-
dered terminals, and between terminals and surround-
ing metallic parts. (See Fig. 1)
Table 1 H Ratings for selected area BERS ESS SO eA ESS eS ECSU CHESS ERLE DSSS IES SCRUBS RASS SETI REESE
AC Line Voltage | Clearance Distance (d), (d’)
23 mm(d)
220 to 240 V = 6 miata
Note: This table is unofficial and for reference only. Oo Exposed Accessible Part
Be sure to confirm the precise values.
2. Leakage Current Test
Confirm the specified (or lower) leakage current
between B (earth ground, power cord plug prongs) AC Voltmeter
and externally exposed accessible parts (RF termi- (High Impedance)
nals, antenna terminals, video and audio input and
output terminals, microphone jacks, earphone jacks,
etc.) is lower than or equal to the specified value in the
table below.
Measuring Method (Power ON) : B & One side of
insert load Z between B (earth ground, power cord Power Cord Plug Prongs
plug prongs) and exposed accessible parts. Use an
AC voltmeter to measure across the terminals of load
Z. See Fig. 2 and the following table.
Table 2: Leakage current ratings for selected areas
; : One side of power cord plug
AC Line Voltage Leakage Current (i) prongs (B) to:
Pcireiae a i<0.7mA AC Peak RF or
parallel is2mA DC Antenna terminals
220 to 240 V
50kQ
RES.
:
j
gene
in
ea
a
aoe
A/V
Input,
Output
Note: This table is unofficial and for reference only. Be sure to confirm the precise values.
1-2-2 SFTY_06