8
2. Setting up the monitor
Resolution notification
This monitor is designed for optimal
performance at its native resolution,
1920×1080@60Hz. When the monitor
is powered on at a different resolution,
an alert is displayed on screen: Use
1920×1080 for best results.
Display of the native resolution alert can
be switched off from Setup in the OSD
(On Screen Display) menu.
Physical Function
Tilt
20
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
2.3 Remove the Base Assembly for
VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the display face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. (1) Use screwdriver to loosen the
screw located at the bottom of
the base.
(2) Use your fingers to loosen the
screw located at the bottom of
the base,and remove the base
from the stand.
3
2
1
To Next Page
Loading...
Need help?
General
