Milk container
Air,steam and milk are mixed at
high speed resulting in a dense
silky smooth milk foam
Steam ows
into the LatteGo
e two LatteGo parts clicked
together create a channel in which
steam pressure sucks up milk
througt the hole at the bottom of
the container
1) Steam inlet
2) Complete LatteGo milk container assy
1
“Water low” message (water reserve)
Function:
e water level is monitored by a capacitive sensor, located one third of the way up
the water tank wall.
If the electronics assembly detects, by means of the sensor, that the amount of
water in the tank has dropped below the above mentioned level, a water reserve
remains available for the dispensing process underway (this will cover 200 ow
meter pulses).
e product dispensing process will then come to an end.
If a dispensing cycle ends aer the sensor has been triggered (in the reserve) then
the display “Water low” continues to be displayed during the following dispensing
cycle.
200 puls.
Sensor
Water tank
Only LatteGo 2.0 is compatible
(421945016211- 421945016221).
Do not use the rst LatteGo
carafe version (421944083391-
421944083621).
Technical information
To Next Page
Loading...
