Need help?Do you have a question about the Philips EP Series and is the answer not in the manual?
General| Capacity | 1.8 L |
|---|---|
| Grinder Type | Ceramic |
| Number of Grinder Settings | 12 |
| Pump Pressure | 15 bar |
| Adjustable Aroma Strength | Yes |
| Adjustable Coffee Volume | Yes |
| Adjustable Milk Volume | Yes |
| Auto Shut-off | Yes |
| Keep Warm Function | Yes |
| Removable Filter Basket | Yes |
| Water Level Indicator | Yes |
| Voltage | 230 V |
Provides an overview of the coffee machine models and interfaces.
Details the water flow within the coffee machine.
Illustrates the electrical wiring diagram of the machine.
Lists technical specifications like volumes, pressure, and dimensions.
Outlines necessary tools for maintenance and repair.
Procedure for measuring coffee temperature in the cup.
Procedure for measuring milk froth temperature and height.
Method to measure milk froth height for CMF and LatteGo systems.
Explains how the gear motor repositions and the boiler heats up.
Provides temperature calibration data for the NTC sensor.
Describes the coffee grinder's motor and transmission.
Explains how the machine detects a blocked coffee grinder.
Details the LatteGo milk container assembly and foam creation.
Explains the function of the water level sensor and "Water low" message.
Explains the function and maintenance of the AquaClean water filter.
How the machine indicates when descaling is needed.
Table showing descaling frequency based on water hardness.
Instructions for greasing and positioning the brew unit.
Safety precautions before starting disassembly.
Steps to remove the outer housing of the machine.
Procedure for removing the User Interface (UI) board.
Steps to remove the coffee grinder assembly.
How to remove the upper and lateral electrovalves.
Instructions for removing the gear motor.
Steps to remove the boiler and its support.
Procedure for removing the flowmeter and its connections.
Steps to remove the coffee and water spout assembly.
Procedure for carefully removing the microswitch.
Steps for removing the mainboard and its fixed wires.
Instructions for removing the pump and securing the thermal fuse.
Explains the purpose of the test mode for mechanics and electronics.
Details how to enter and navigate the test mode levels.
Describes Level 0 functions, including error log reset.
Covers testing buttons, LEDs, and the buzzer in Level 1.
Details testing loads and sensors in Level 2.
Conditions and LED indications for starting test mode at Level 0.
Details sequences for testing buttons, LEDs, and identifying causes of failure.
Details sequences for testing buttons, LEDs, and identifying causes of failure.
Details sequences for testing loads and sensors, including failure analysis.
How to enter and perform the Steam Out function.
Lists detailed coffee volume specifications for different drink types.
Step-by-step guide for descaling the machine.
Instructions for handling an interrupted descaling process.
A temporary solution for securing the pump with a cable tie.
Instructions for applying adhesive tape for service door security.
Information about the EPSC tool for software uploads and diagnostics.
Steps to turn off the AquaClean filter reminder notification.
Procedure to disable button beep sounds.
How to restore default drink settings and preferences.
Outlines the step-by-step process for repairing the appliance.
To Next Page
