PHI 5000 LATTE GO / GO+ 03 OPERATING LOGIC
4/8
3.8. Water level detection (water tank)
“Water low” message (water reserve)
Function:
e water level is monitored by a capacitative sensor, located one third of the
way up the water tank wall.
If the electronics assembly detects, by means of the sensor, that the amount
of water in the tank has dropped below the above mentioned level, a water
reserve remains available for the dispensing process underway (this will
cover 200 ow meter pulses).
e product dispensing process will then come to an end.
If a dispensing cycle ends aer the sensor has been triggered (in the reserve)
then the display “Water low” continues to be displayed during the following
dispensing cycle.
200 puls.
Sensor
Water tank
3.7. Milk container
Air,steam and milk are mixed
at high speed resulting in a
dense silky smooth milk foam
Steam ows
into the LatteGo
e two LatteGo parts clicked
together create a channel in
which steam pressure sucks up
milk througt the hole at the
bottom of the container
1) Steam inlet
2) Complete LatteGo milk container assy
1
2
To Next Page
Loading...