PHI 5000 LATTE GO / GO+ 08 DISASSEMBLY
2/7
Unscrew the screw
shown and remove
the cover.
Unscrew the screw shown
Press the sides and remove the cover and
dispenser. Insert as before to reassemble the
dispenser in the rail and then the coverage.
7.2. Dispenser
Unscrew the screws shown
Unscrew the screws shown and
remove the dispenser
unlock where highlighted and re-
move the cover in the dispenser
Remove the insert the upper cover
Remove the support KYB assy.
and disconnect the at cable.
Remove the upper cover and remove the electrical and
water circuit connections.
remove the block support
KYB assy.
To Next Page
Loading...