PHI 5000 LATTE GO / GO+ 04 DIAGNOSTIC MODE
8/8
Start condition
The grinder rotates and in the indication GRINDER the number increas-
ing up to 40. The other numbers inside the GRINDER box are not impor-
tant for this test.
Press the Z4 button to switch on the grinder
IMPORTANT NOTE: If the COFFEE BEANS Cover is not inserted the Grind-
er test cannot be performed. If this input is not in the right position, a
warning message will be shown and the display turns to RED.
120V
4.3. SteamOut
To enter in SteamOut
The machine enters in Steam-Out mode by holding
pressed together:
the “Coffee” button and the MENU button;
while switching on the machine by main switch
behind the machine.
This document describes the Steam-Out procedure; the application is used in order to empty the
heater.
Not mandatory, but if necessary, before executing the steam out procedure, descale the machine
taking care to remouve the Aquaclean lter from the appliance.
In case the lter on the machine is active (or it’s in the machine) provide the consumer with a
new one.
Once entered the Steam Out mode the display shows the “STEAM OUT”
indication. Buttons can be released.
IMPORTANT NOTE: to execute the Steam-out procedure the Ntc sensor
must work correctly; if some errors occurs on Ntc during the steam-out,
the procedure can’t continue and an error message is shown on the dis-
play.
IMPORTANT NOTE: to execute the Steam-Out procedure the DREG-
DRAWER must be in place and the DOOR must be closed.
If these 2 conditions are not respected a warning message is shown on
the display and the Steam-Out is interrupted.
The machine starts the Steam Out and in the display appears the indica-
tion “ON”.
While the Steam Out runs the Electro valve is opened and water comes
out the Water/Steam pipe.
When the Steam Out is complete the message “COMPLETE” is shown on
the Display.The Electro valves automatically closes and the machine can
be switched off.
To Next Page
Loading...