1 = Enabled
I – CTCSS Options 0 = no CTSS
1 = CTSS variable per channel
2 = variable via keyboard
3 = variable per channel, RTB (Reverse Tone Burst)
4 = variable via keyboard, RTB
5 = Community Repeater (CR) per channel
6 = via keyboard and CR
7 = CR per channel and RTB
J – Tone Period 0 = no tone period
1 = 100 ms
1 = 40 ms
1 = 70 ms
1 = 20 ms
1 = 33 ms
K – Simplex Mode 0 = simplex mode (no other option selectable)
LL - Selcall encode (only selectable if selcall is fitted, otherwise program 00)
Selections available: 00-05, 07-09, 11, 12, 15, 16 ,27 ,28,
35 ,36 ,43 ,44 ,51-53
MM - Selcall decode (only selectable if selcall is fitted, otherwise program 00)
Selections available: 00-18 for selcall type 2
00, 31-46, 50, 51 for selcall type 1
Note on Selcall software selection codes: selection of all codes is not
available to all radios. See selcall selection chart for the type of radio
you have. (not included here due to large size & complexity)
Common error messages:
* Selecting CTCSS tones without the correct hardware being installed at the
hardware code and the like will cause error messages. This applies to things
like selcall setups etc.
* TX inhibit cannot be selected with Community repeater
* Tone periods 33 & 20 ms are incompatible with type 2 selcall.
* Voting cannot be selected with mute defeat.
* Selcall decode (in software code) must =00 if encode =03 or =07
* Selcall encode 04 & 08 with decode 00 is an invalid combination if type 2
selcall is fitted
* Selcall software code 0400 & 0800 can still be used for special applications
(no decode, ident with PTT, and base selcall encode when operating ‘send’
button)
* Community repeater must have CTCSS encode/decode hardware available, and
requires CTCSS tone to be entered.
* Voting isn't selectable without NSC810 I/O expander hardware
* Can only have duplicate channel numbers with voting selected on those
duplicate channel numbers
* Cannot select economiser and voting on same channel
* Cannot select economiser and selcall on same channel
* Cannot select selcall and scanning on same channel
* Must have more than one channel in a vote group
Philips FM92E Conversion to 6 Meters: Version 3.9 Page 74
To Next Page
Loading...
