Philips FR975 - Audio Selector

1-3
PCS 102 483
SPECIFICATION FR975
General
Mains voltage :230V for /00
:110-127V / 220-240
switchable only /01/01C
: 120V for /17
Mains frequency : 50Hz for /00
: 50/60Hz for /01/01C
: 60Hz for /17
Power concumption : ≤ 2W at stby
: ≤ 3W at stby 240V/01/01C
Dimension. wxhxd : 435x138x350 mm
Remote control : Multibrand/Universal
Amplifier
Output power
Stereo mode (L+R) : 2x100W DIN only /00/01
(1kHz,0,7%THD, 6Ω)
: 2x80W FTC only /17
(40Hz-20kHz 0,7%THD, 6Ω)
Surround mode
L+R : 2x100W (1kHz,0,7%THD, 6Ω)
Center : 100W (1kHz,0,7%THD, 6Ω)
Surround Left+Right : 2x100W (1kHz,0,7%THD, 6Ω)
Distortion (5W)
1kHz : ≤ 0,05%
40Hz - 20kHz : ≤ 0,2%
Headphone : 6,3mm stereo jack with switch
Output level : 3V EMF, 60Ω
Crosstalk between source —1kHz : ≤ -65dB
(1W) 250Hz – 10kHz : ≤ -60dB
Crosstalk between channels -1kHz : ≤ -55dB
(1W) 250Hz – 10kHz : ≤ -50dB
Frequency response
: ≤ 10Hz – ≥ 20kHz (-3dB) Limit
Power stage protection : Shortcircuit
: DC (Vout ≥ 10V) for ±1sec
Temperature : Transformer ( ≥140º Celcius)
: Heatsink ( ≥ 140º Celcius)
Audio Selector
Input sensitivity
Phono : 5mV impedance 47kΩ/220pf
CD : 250mV impedance ≥ 47kΩ
CDR/TAPE : 250mV impedance ≥ 47kΩ
VCR : 250mV impedance ≥ 47kΩ
TV : 250mV impedance ≥ 47kΩ
SAT : 250mV impedance ≥ 47kΩ
6CH / DVD : 250mV impedance ≥ 47kΩ
FRONT AV : 250mV impedance ≥ 22kΩ
Output level
CDR/TAPE : 250mV impedance ≤ 1kΩ
VCR : 250mV impedance ≤ 1kΩ
Output level (variable)
Subwoofer pre-out : 800mV impedance ≤ 1kΩ
Center pre-out : 800mV impedance ≤ 1kΩ
Digital Selector
Input : 2 x cinch
: 2 x optical
Output : 1 x cinch
Video Selector - CVBS
Input sensitivity
DVD/VCR/TV/Front AV : 1 Vpp impedance 75Ω
Output level
Monitor/VCR : 1 Vpp impedance 75Ω
Frequency response : ≤ 50Hz à ≥ 6MHz
Video Selector - SVHS
Input sensitivity
DVD/VCR/TV : 1 Vpp impedance 75Ω
Output level
Monitor/VCR : 1 Vpp impedance 75Ω
Frequency response : ≤ 50Hz à ≥ 6MHz
Tone controle
Loudness
(volume ≤ -20dB Ref: 1kHz=0dB) : 100Hz +6 dB
: 10kHz +2,5 dB
Tone control (Ref: 1kHz=0dB)
: Bass 100Hz -9dB à+9dB
: Treble 10kHz -9dB à+9dB
Multi Channel Decoder - MDM2000
MPEG5.1 / MPEG 7.1 (7.1 downmix to 5.1)
Dolby Digital (AC-3)
Digital Theater Systems (DTS)
Linear PCM (up to 96kHz, 24 bits resolution)
Automatic audio/data type detection (AC-3,dts,MPEG-2,PCM)
Dolby Pro Logic
MPEG-2 dual mono channel selection I/II
Virtual Dolby Surround (422/423)
Virtual MPEG Digital (522/523)
Virtual Dolby Digital (522/523)
Virtual DTS Surround (522/523)
Multi - Front / Multi - rear / Natural Surround
Digital Bass Management
Parallel Stereo Downmix
Four Stereo (224)
Volume Control
Noise Generator (test tone)
Surround mode selector
Delay Center and Surround Left , Surround Right
Tuner - (Tuner95 & ECO5)
RDS : Only in /00
FM
Tuning range : 87.5 – 108MHz
Grid : 50kHz
: 100kHz only for /17
: 50 & 100kHz for /01/01C*
IF frequency : 10.7MHz ±25kHz
Aerial input : 75 Ω coaxial
: 300 Ω clickfit only for /17
Sensitivity at 26dB S/N : ≤ 2µv
Selectivity at 300kHz : ≥ 55dB
Image rejection : ≥ 100dB [48dB]
Distortion at RF=1mV,dev.75kHz : ≤ 0,8% [0,9%]
-3dB Limiting point : ≤ 2µV
Crosstalk at RF=1mV,dev.40kHz : ≥ 35dB [27dB]
: ≥ 22dB only for /17
MW
Tuning range : 522 -1611kHz for /00
: 531 -1602kHz for/01/01C*
: 530 -1700kHz for/01/01C*
: 530 -1700kHz for /17
Grid : 9kHz for /00
: 9 & 10kHz for /01/01C*
: 10kHz for /17
IF frequency : 450kHz ±1kHz
Aerial input : Frame aerial
Sensitivity at 26dB S/N : ≤ 1,5mV/m [3,5mV/m]
Selectivity at 9kHz : ≥ 23dB [18dB]
IF rejection : ≥ 50dB [64dB]
Image rejection : ≥ 33dB [28dB]
Distortion at RF=50mV,m=80% : ≤ 3%
LW only in /00
Tuning range : 153 - 279kHz
Grid : 3kHz
IF frequency : 450kHz ±1kHz
Aerial input : Frame aerial
Sensitivity at 26dB S/N : ≤ 2,8mV/m
Selectivity at 9kHz : ≥ 26dB
: ≥ 24dB only for /17
IF rejection : ≥ 100dB
Image rejection : ≥ 45dB
Distortion at RF=50mV,m=80% : ≤ 3%dB
[…] Values indicated are for “ECO 5 Tuner” only
* Setting is software controlled
www.freeservicemanuals.info
07/08/2012
World of Free Manuals