Philips FW 316C - Timer Setting for Automatic Operation

tH.
4
20
AMER
Timer Settin
ot
The system can switch on to CD or TUNER mode
automatically at a preset time. It can serve as an
alarm to wake you up. After half an hour from the
preset time, the system will return to the standby
mode if no button is pressed.
Before setting the timer, make sure the clock is set
correctly.
The timer has to be reset or start again for each
subsequent preset time.
The volume of the timer will be at the last setting
before the set is switched to standby mode.
Press and hold CLOCKeTIMER for more than Z
seconds to select timer mode.
— "ON 22:22" or the last set timer starts flashing.
The TIMER flag flashes.
— The last selected source is lighted while other
available sources are flashing.
—+ "dq b> id Pi, Mt light up (for model
FW339C only):
Press CD or TUNER to select the desired source.
Press <4 or >> to set the hour for the timer to start.
Press I¢ or I to set the minute for the timer to
Start.
Press CLOCKeTIMER to store the start time.
— The TIMER is now set. |
— The TIMER flag remains on the display.
Jo exit without storing the setting, press STOP Ml.
At the preset time, the TIMER will be activated.
— The selected source will be played.
~ The TIMER flag disappears from the display.
Notes:
— During timer setting, if no button is pressed within 90
seconds, the system will exit timer setting mode
automatically.
— /f the source selected is TUNER, the last tuned
frequency will be switched on.
— If the source selected is CD, playback will begin with
the first track of the last selected disc. If the CD trays
are empty, the TUNER will be selected instead.
To start the TIMER again (for the same time]
1 Press CLOCKeTIMER for more than 2 seconds.
2 Press CLOCKeTIMER again to store the start time
and the selected source.