Philips FW 316C - Playing, Changing, and Selecting Tracks; Programming and Managing CD Playlists

Playing a CD
1 Press PLAY > to start playback.
— The disc tray, track number and elapsed playing
time of the current track appear on the display.
e To interrupt playback, press PAUSE 1.
— The playing time flashes.
e To resume playback, press PLAY >» again.
2 To stop playback, press STOP MM.
Note:
— All the available discs will play once, then stop. When
the CD has stopped playing, the system will switch to
the standby mode after 15 minutes if no button is
pressed.
Disc Change
You can change the outer 2 discs while the third inner
disc is at the stop or playing mode.
1 Press DISC CHANGE.
— The CD compartment slides out.
2 Replace the discs in the left and right disc trays.
¢ If you press DISC CHANGE again during playback,
the CD will stop playing.
— The CD carousel tray will rotate until the inner tray
is at the right hand side and is ready for changing.
3 Press OPEN*CLOSE to close the CD compartment.
*
ar woe Se Ae ae
Selecting a desired track
Selecting a desired track at the stop mode
1 Press PREV I4 or NEXT PI until the desired ack
- appears on the display. -
2 Press PLAY > to start playback.
— The selected track number and elapsed playing
time appear on the display.
Selecting a desired track during playback
1 Press PREV i or NEXT Pi until the desired track
appears on the display.
— The selected track number and elapsed playing
time appear on the display.
° If you press PREV I once it will skip to the
beginning of the current track and play the track again.
Searching for a particular passage
during playback |
e Press and hold <4 or >> until the desired passage is
located.
— The volume will be reduced.
e Play returns to normal when <4 or >> is released.
« ‘ vee Dw - ~- “ate . oa
Pm ee mR ee en et ee rn Be ee he Pa
Programming Tracks
Programming tracks of a loaded CD is possible in the stop
mode. The display will indicate the total tracks stored in
the program. Up to 40 tracks can be stored in the memory
in any order. When 40 tracks are stored and you attempt
to store another track, the display will show “PROGRAM
PULL”.
1 Load the desired discs in the disc trays.
2 Press PROGRAM to start programming.
— The PROGRAM flag starts flashing.
3 Press the CD 1°CD 2°CD 3 button to select the disc.
4 Press PREV [4 or NEXT Pl to select the desired
track.
5 Press PROGRAM to store the track.
Repeat steps 3to Sto store other discs and tracks.
6 Press STOP Mi once to end programming mode.
— The total number of tracks programmed and total
playing time appear on the display.
Notes:
— If the total playing time is more than “99:59 " or if
one of the programmed tracks has a number greater
than 30, then “- -:- - ” appears in the display instead
of the total playing time.
— During programming, if no button is pressed within 20
seconds, the system will exit program mode
automatically. -
13