3139 115 20462 (ENG)
25
TIMER SLEEP TIMER
Notes:
– During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically.
– If the source selected is TUNER, the
last tuned frequency will be switched
on.
– If the source selected is CD, playback
will begin with the first track of the
selected disc or program. If the disc
trays are empty, the TUNER will be
selected instead.
– The timer will not activate if a recording
is in progress.
To switch off the TIMER
1 Press and hold CLOCK•TIMER
for more than two seconds.
2 Press Ç on the system to cancel the
timer.
➜ The timer is now switched off.
➜ The display will show "OFF" and
the TIMER disappears.
To start the TIMER again (for the
same preset time and source)
1 Press and hold CLOCK•TIMER
for more than two seconds.
2 Press CLOCK•TIMER again to
store the start time.
➜ The timer is now on.
➜ The TIMER appears on the display.
Sleep Timer (only on remote
control)
This feature allows you to select a
length of time after which the system
will switch to the standby mode
automatically.
1 Press SLEEP on the remote control
repeatedly to select a period of time.
➜ The selections are as follows (time
in minutes): 15 ™ 30 ™ 45 ™ 60
™ OFF ™ 15 …
➜ "SLEEP XX" or "OFF" will be
displayed. "XX" is the time in
minutes.
2 When you reach the desired length
of time, stop pressing the SLEEP
button.
➜ The SLEEP display lights up.
➜ The Sleep Timer is now set. Before
the system switches to standby
mode, a countdown of 10
seconds will be displayed.
"SLEEP 10" ™ "SLEEP 9".... ™
"SLEEP 1" ™ "SLEEP"
While SLEEP mode is activated
¶ Press SLEEP once to view the
remaining length of time.
¶ Press SLEEP twice to change the
pre-selected period of time.
➜ The display will show the
remaining time followed by the
sequence of sleep timer options.
To switch off the Sleep Timer
¶ Press SLEEP repeatedly until "OFF"
is displayed, or press the
STANDBY-ON button.
pg 01-30/C380/37-En 12/6/00, 2:21 PM25
To Next Page
Loading...
