Basic Functions
12
English
IMPORTANT!
Before you operate the system,complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
RDS stations and radio stations automatically.
If Plug and Play has not been installed
1 When you turn on the system,"AUTO
INSTALL - PRESS PLAY" will be displayed.
2 Press PLAYÉ on the system to start
installation.
➜ "INSTALL" will be displayed and followed by
"TUNER" and then "AUTO".
➜ PROG will start flashing.
➜ The system will search for all RDS stations
and then continue with radio stations on FM
and MW band respectively. Weak RDS
stations may be stored in later presets.
➜ All available RDS and radio stations with
sufficient signal strength will be stored
automatically.
➜ The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
➜ The last preset radio station or the first
available RDS station will play when Plug and
Play is completed.
3 The system will proceed to set the RDS time
automatically with the stored RDS preset station.
● If no RDS station is found in the first preset
station;
➜ The programme will exit automatically.
● If RDS radio station is found;
➜ "INSTALL" will be displayed and followed by
"TIME".
● When searching RDS time;
➜ "SEARCH RDS TIME" will be displayed.
➜ When RDS time is read,"RDS TIME" and
RDS time logo ( ) will be displayed. The
current time will be displayed for 2 seconds
and stored automatically.
➜ If RDS station does not transmit RDS time
within 90 seconds,the programme will exit
automatically and the display will show “NO
RDS TIME”.
To reinstall Plug and Play
1 In Standby or Demonstration mode,press and
hold PLAYÉ on the system until "AUTO
INSTALL - PRESS PLAY" is displayed.
2 Press PLAYÉ again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
● Press Ç on the system.
To Next Page
Loading...
