CD Operation
17
English
Disc Playback
To playback all discs on the disc tray
● Press PLAYÉ.
➜ All the available discs will playback once, then
stop.
➜ During playback,the selected disc tray, track
number and elapsed playing time of the
current track will appear on the display.
To playback one disc only
● Press the DISC DIRECT PLAY button : DISC 1,
DISC 2 or DISC 3.
➜ The selected disc will playback once,then
stop.
To interrupt playback
● Press PAUSEÅ.
● To resume playback,press PLAYÉ again.
To stop playback
● Press Ç.
To search for a particular passage during
playback
● Press and hold à or á and release it when the
desired passage is located.
➜ During searching, the volume will be reduced.
To select a desired track
● Press í or ë repeatedly until the desired track
appears on the display.
● If playback is stopped,press PLAYÉ to start
playback.
Note:
– In Shuffle mode,pressing
í
will cause the
player to skip only to the beginning of the current
track.
To skip to the beginning of the current
track during playback
● Press í once.
Replace discs during playback
1 Press DISC CHANGE.
2 To change the inner disc,press DISC
CHANGE again.
➜ "DISC CHANGE" will be displayed and the
disc will stop playing.
➜ The disc tray will close to retrieve the inner
disc, then reopen with the inner disc
accessible.
Programming the disc tracks
Programming tracks is possible when playback is
stopped.Up to 40 tracks can be stored in the
memory in any order.
1 Load the desired discs on the disc tray (refer to
“Loading Discs”).
2 Press PROG to start programming.
➜ PROG will start flashing.
3 Press CD (CD 1•2•3) or DISC 1/2/3 button to
select a disc.
4 Press í or ë repeatedly to select the desired
track.
5 Press PROG to store the track.
● Repeat steps 3–5 to store other discs and tracks.
6 Press PLAYÉ to start programme playback.
➜ "PLAY PROGRAM" will be displayed.
● To end programming without starting playback,
press Ç once .
➜ The total number of tracks programmed and
the total playing time will appear on the
display.
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30,then "--:--" will appear on the
display instead of the total playing time.
– If you attempt to programme more than 40
tracks,"PROGRAM FULL" will be displayed.
– If you press any of the DISC DIRECT PLAY
buttons, the system will playback the selected disc
or track,and the stored programme will be ignored
temporarily.The prog symbol also will disappear
temporarily from the display. It will reappear when
playback of the selected disc ends.
– During programming,if no button is pressed
within 20 seconds, the system will exit the
Programme mode automatically.
To Next Page
Loading...
