23
English
To rewind or fast forward when playback
is stopped
1 Press à or á.
2 Press Ç when you reached the desired passage.
To reset tape counter number
● When in stop mode, pressÇ.
➜ “T1 000” or “T2 000” will be displayed.
Notes:
– During rewinding or fast forwarding of a tape,it
is also possible to select another source (CD,TUNER
or AUX, for example).
– The tape counter will automatically set to zero
after detecting end of tape.
Dolby B Noise Reduction System
● Press DOLBY B NR repeatedly to switch on
or off the Dolby B noise reduction system.
➜ If activated, will appear on the display.
Note:
– A tape recorded with the Dolby B NR system
should also be played in the Dolby B NR mode.If
not,the treble may be reproduced too strongly.
General Information on
Recording
● For recording,use only tape of IEC type I (normal
tape).
● The recording level is set automatically, regardless
of the position of the Volume,VAC,DSC and so
forth.
Dolby B NR can be selected for Tuner or CD
recording.
● The tape is secured at both ends with leader
tape. At the beginning and end
of the tape, nothing will be
recorded for six to seven
seconds.
● To prevent accidental recording,
break out the tab on the left
shoulder of the tape side you
want to protect.
● If “CHECK TAPE”is displayed, the protection tab
has been broken. Put a piece of clear adhesive
tape over the opening.
IMPORTANT!
– Recording is permissible if copyright or
other rights of third parties are not infringed
upon.
– Recording is possible only on tape deck 2.
Preparation for Recording
1
Press TAPE (TAPE 1•2) to select TAPE 2.
2 Load a recordable tape into tape deck 2.
3 Press í or ë to select the recording tape side.
➜ Ñappears on the display for the reverse side.
➜ Éappears on the display for the forward
side.
Tape Operation/Recording
To Next Page
Loading...
