34
English
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
●
The system can be used as an alarm clock,
whereby DISC, USB or TUNER is switched on at a
set time. The clock time needs to be set first
before the timer can be used.
1 In active mode, press and hold TIMER on the
remote control for more than three seconds.
➜ "ON TIME" flashes.
2 Press TIMER to enter the time setting mode.
➜ The hour digits flash on the display screen.
3 Tur n VOLUME +/- on the front panel or press
VOL +/- on the remote to set the hours and
then press TIMER to confirm.
➜ The minute digits flash on the display screen.
4 Tur n VOLUME +/- on the front panel or press
VOL +/- on the remote to set the minutes and
then press TIMER to confirm.
➜ "ON TIME" flashes.
5 Tur n VOLUME +/- on the front panel or press
VOL +/- on the remote to select “SOURCE”.
6 Press TIMER to enter the source setting mode.
7 Press SOURCE on the front panel repeatedly
or press
DISC, USB/MP3 LINK or TUNER
on
the remote to select source and then press
TIMER to confirm.
● Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
USB – connect a suitable USB device.
TUNER – tune to the desired radio station.
For TUNER mode:
a. Tur n VOLUME +/- on the front panel or
press VOL +/- on the remote to select a preset
station and then press TIMER to confirm.
8 Tur n VOLUME +/- on the front panel or press
VOL +/- on the remote to select “VOL XX”.
9 Press TIMER to enter the volume setting mode.
0 Tur n VOLUME +/- on the front panel or press
VOL +/- on the remote to set the volume level
and then press TIMER to confirm.
➜ The timer is now set.
● In active mode, press TIMER ON/OFF on the
remote control to activate or deactivate the
timer.
➜ appears if activated, and disappears if
deactivated.
Notes:
– Only DISC, USB and TUNER can be selected as
the source for the timer.
– The system will exit the timer setting mode if no
button is pressed within 10 seconds.
pg019-pg040_FWD18_98-Eng 2008.5.20, 17:1434
To Next Page
Loading...
