Philips FWD872/98 - Connecting the System to Your TV Set

11
English
Using component Video In jack (Pr Pb Y)
● Use the component video cables (red/blue/
green) to connect the system’s PR PB Y jacks
to the corresponding Component video input
jacks (or labeled as Pr, Pb, Y or YUV) on the TV
set.
● To listen this system channels through TV , use
the audio cables (white/red) to connect AUX
IN (L/R) jacks to the corresponding AUDIO
OUT jacks on the TV set.
● If you are using a Progressive Scan TV set (TV
with Progressive Scan or ProScan capability),
activate the PROGRESSIVE SCAN function
through SYSTEM MENU.
Connections
Step 3: Connecting TV set
IMPORTANT!
–You only need to make one video
connection from the following options,
according to the capabilities of your TV
system.
– S-Video or Component Video
connection provides higher picture quality.
These options must be available on your
TV set.
– Connect the system directly to the TV
set.
Using Video In jack (CVBS)
● Use the composite video cable (yellow) to
connect the system’s VIDEO jack to the video
input jack (or labeled as A/V In, Video In,
Composite or Baseband) on the TV set.
Using LINE OUT jack (L/R)
To listen this system channels through TV , use the
audio cables (white/red) to connect LINE OUT
(L/R) jacks to the corresponding AUDIO IN jacks
on the TV set.
OUT
IN
fwd872-98 UM v1.0 2007.12.10, 17:2611