32
English
Tuner Operations
IMPORTANT!
– Make sure FM and MW antennas are
connected.
Tuning to radio stations
1 Press TUNER key on the front panel
repeatedly until “FM XX” or “MW XX” appears
on the display panel ( or press TUNER key on
the remote control)
2 Press and hold 1 / ¡ on the system or on
the remote control until “SERACH->”appeared,
then release.
➜ The first radio station with sufficient signal
strength will appear on the display.
3 To tune a weak station, press 1 / ¡ on the
system or on the remote control to search until
a radio station with sufficient signal strength is
found.
Presetting radio stations
You can store up to 40 preset radio stations in
the memory, starting from FM and followed by
MW bands. There are three different ways to
program the radio stations:
- Using auto install (for first time setup only)
- Automatic preset programming
- Manual preset programming
Note:
- If no stereo signal is detected during tuner
installation, “ NO SIGNAL PLEASE CHECK
ANT” will appear on the VFD.
Using auto install
When you plug in the unit for the very first
time,you will be prompted to install the radio
stations. With this feature, you can install all the
available tuner station automatically with one
touch of button.
When “ AUTO INSTALL PRESS PLAY”
appears.
● Press 38 on the system,
➜ This until starts searching from the FM band
followed by the MW band.
➜ All the available radio stations with strong
signal will be strored automatically.
➜ When all the available radio stations are
stored or the memory for 40 presets are
used,the first preset radio station will be played.
Automatic preset programming
You can start automatic presetting from a
selected preset number.
1 Press TUNER key to select TUNER mode.
➜ The current radio frequency will appear on
the display.
To begin automatic preset from a desired
preset number
● Press O / P or numeric keys (0-9) to
select the desired preset number.
2 Press and hold PROGRAM on the remote
control until “>>> AUTO ” appears on the
display.
➜ The system will start to search all radio
stations on the FM band, then MW band.
➜ All radio stations with strong signal strength
will be stored automatically.
➜ The system will stop searching when all
available radio stations are stored or when the
memory of 40 preset radio stations is full.
➜ If no stereo signal is detected during tuner
installation, “ NO SIGNAL PLEASE CHECK
ANT” will appear on the VFD.
To stop storing the automatic preset
● Press 7 to stop storing the automatic preset.
fwd872-98 UM v1.0 2007.12.10, 17:2632
To Next Page
Loading...
