8 Fill the water tank with fresh water up to the MAX indication
The machine is ready for use.
Note: The automatic rinsing cycle starts when the machine has been in
stand-by mode, or switched off , for more than 30 minutes. When you
have not used the machine for 2 or more weeks, you will need to perform
a manual rinse cycle.
Measuring the water hardness
To be able to adjust the machine settings to the water in your region, please
measure the water hardness with the water hardness strip supplied.
1 Immerse the water hardness test strip (supplied with the machine) in
fresh water for 1 second.
2 Remove the water hardness strip and and wait for 1 minute.
3 Check how many squares have changed into the red color and check the
water hardness in below table.
numbers of red squares
value to be set water hardness
1/2 A very soft water/ soft water
3 B hard water
4 C very hard water
Installing the Intenza+ water filter
We advise you to install the Intenza+ water filter as this prevents scale
build-up in your machine. You can buy the Intenza+ water filter separately.
For more details, see chapter ‘Guarantee and support’, section ‘Ordering
maintenance products’.
Note: Replace the INTENZA+ filter after 2 months.
1 Remove the small white filter from the water tank and store it in a dry
place.
Note: Please keep the small white filter for future use. You will need it for
the descaling process.
12
English
To Next Page
Loading...
