-
The HOT WATER/MILK CLEAN button flashes twice.
5 Press the HOT WATER/MILK CLEAN button once to stop frothing.
Note: after dispensing a milk based beverage perform a quick clean of
the milk circuit. dispense hot water for about 5 seconds, see chapter
'Maintenance and care', section 'Daily cleaning of the automatic milk
frother'.
Hot water
Inserting and removing the hot water dispensing spout
To insert the hot water dispensing spout:
1 Tilt the hot water dispensing spout slightly and insert it into the machine.
2 Press and turn the hot water dispensing spout downwards to lock it in the
machine.
To remove the hot water spout:
1 Press the release buttons on the sides of the hot water dispensing spout
to unlock it.
2 Lift the hot water dispensing spout slightly and pull it out of the machine.
Dispensing hot water
Caution: Steam and hot water may spray out of the hot water dispensing
spout when brewing starts. Wait until the cycle has ended before
removing the hot water dispensing spout.
1 Place a cup under the hot water dispensing spout.
2 Press the HOT WATER/MILK CLEAN button once.
-
The HOT WATER/MILK CLEAN button flashes slowly.
-
Hot water dispensing starts automatically.
3 Press the HOT WATER/MILK CLEAN button once to stop hot water
dispensing.
Adjusting quantity and taste
Saeco Adapting System
Coffee is a natural product and its characteristics may vary according to
origin, blend and roasting. The machine is equipped with a self-adjustment
system that allows it to get the best taste out of your favorite coffee beans.
It regulates itself after brewing some coffees.
17
English
To Next Page
Loading...
