pause the descaling or rinsing cycle by pressing the ESPRESSO button. To
continue the descaling or rinsing cycle, press the ESPRESSO button.
Descaling procedure
1 Insert the hot water dispensing spout. (if it is not installed).
2 Remove and empty the drip tray and coffee grounds container. Place the
drip tray and coffee grounds container back into place.
3 Remove the water tank and the “INTENZA+” water filter from the water
tank (if present), replace it with the small white original one.
4 Pour the descaling solution in the water tank. Fill the water tank with
fresh water up to the CALC CLEAN level. Place the water tank back in the
machine.
5 Place a large container (1.5 l) under both the hot water/steam wand and
coffee dispensing spout.
Aroma plus
Hot water
Espresso
Memo Memo
Calc
clean
Coffee
Milk clean
Memo
Cappuccino
6 Press and hold the CALC CLEAN button for 3 seconds to start the
descaling cycle. The ESPRESSO button lights up continuously and the
CALC CLEAN button flashes throughout the cycle.
Aroma plus
Hot water
Espresso
Memo Memo
Calc
clean
Coffee
Milk clean
Memo
Cappuccino
7 The descaling cycle light lights up continuously. The machine starts
dispensing the descaling solution at intervals for approximately 20
minutes.
Aroma plus
Hot water
Espresso
Memo Memo
Calc
clean
Coffee
Milk clean
Memo
Cappuccino
8 Let the machine dispense the descaling solution until the no water light
lights up continuously.
9 Remove the water tank and rinse it. Fill the water tank with fresh water up
to the MAX level and place it back in the machine.
10 Empty the drip tray and container and place it back.
11 The rinse cycle light lights up continuously. When the ESPRESSO button
flashes, press it to start the rinsing cycle.
12 When the rinsing cycle is finished the CALC CLEAN button goes out.
25
English
To Next Page
Loading...
