To Next PageTo Next PageHow to make my Philips Coffee Maker coffee hotter?
If your coffee is not hot enough, preheat the cups with hot water. You can also set the temperature as described in the 'Programming' chapter.
Why does coffee leak out of the dispensing spout of my Philips HD8831/00 Coffee Maker?
Coffee may leak out of the dispensing spout because the dispensing spout is clogged. Clean the dispensing spout and its holes.
What to do if the descaling cycle cannot be completed on my Philips HD8831/00 Coffee Maker?
If the descaling cycle cannot be completed because the water dispensed for the rinse cycle is not enough, press the on/off button and follow the instructions.
Why does my Philips HD8831/00 not turn on?
If your Philips Coffee Maker does not turn on, ensure that the machine is connected to the electric network and that the power button is in the “I” position.
Why is the coffee from my Philips Coffee Maker too weak?
The coffee from your Philips Coffee Maker might be too weak because the machine is automatically adjusting the dose. Brew a few cups of coffee as described in the “Saeco Adapting System” chapter.
What to do if my Philips HD8831/00 Coffee Maker is brewing coffee slowly?
If your Philips Coffee Maker is brewing coffee slowly, it could be due to several reasons. The coffee grind may be too fine, the dispensing spout may be dirty, the brew group could be dirty, or the machine circuit might be clogged by limescale. Clean the dispensing spout and its holes and descale the machine. Also, consider changing the coffee blend or adjusting the grinding. Priming the circuit might also help.
Why is no hot water or steam dispensed from my Philips HD8831/00?
If no hot water or steam is dispensed from your Philips Coffee Maker, the hole of the steam/hot water wand may be clogged. Clean the hole of the steam wand using a pin. Also, the machine circuit may be clogged by limescale, so descale the machine. Priming the circuit might also help.
Why is the red icon always displayed on my Philips Coffee Maker?
The red icon might be displayed because the coffee grounds drawer was emptied while the machine was off. The coffee grounds drawer must always be emptied with the machine on. Wait until the icon is displayed before refitting the drawer. Also, if the coffee grounds drawer has been emptied with the machine on without waiting at least 5 seconds before inserting it back, wait until the icon is displayed before refitting the drawer.
What to do if my Philips Coffee Maker shows Error Code 5?
If your Philips Coffee Maker displays Error Code 5, it indicates a water circuit error. This can be due to air in the water circuit. To resolve this, remove and reinsert the water tank a few times, ensuring it's properly reinserted and that the water tank compartment is clean. If the Intenza+ filter is installed, remove it, turn the machine off and on, and then reinsert the filter when the machine is ready.
What to do if the brew group cannot be removed from my Philips HD8831/00?
If the brew group cannot be removed, turn on the machine and close the service door so that the brew group automatically returns to the initial position. Also, remove the coffee grounds drawer before removing the brew group.
General| Appliance placement | Countertop |
|---|---|
| Product type | Espresso machine |
| Model | HD8831/00 |
| Coffee input type | Coffee beans |
| Water tank capacity | 1.8 L |
| Coffee beans capacity | 250 g |
| Built-in grinder | Yes |
| Adjustable grinder settings | Yes |
| Number of grinder settings | 5 |
| Milk tank | No |
| Adjustable coffee strength | Yes |
| Adjustable coffee volume | Yes |
| Hot water system | Yes |
| Steam pipe | Yes |
| Pre-brew aroma control | Yes |
| Self-cleaning | Yes |
| Removable brewing unit | Yes |
| Removable water tank | Yes |
| Power | 1850 W |
| Voltage | 230 V |
| Weight | 7.2 kg |
| Colour | Black |
| Pump Pressure | 15 bar |
| Coffee maker type | Automatic |
