Philips HMP4000 - Settings

18 EN
5 Setup
You can change the setup options of HMP4000.
1 On the Home screen, select [Setup].
• If necessary, press on the remote control to go to the Home screen.
» The setup menu is displayed.
2 Press to select an option. Press OK to conrm the option.
• Press to return to the upper-level menu.
System
[Menu Language]: Select the language for onscreen menus.
[Subtitle]: Select the subtitle language for videos.
[ScreenSaverDelay]: Enable the screen saver when HMP4000 is in the idle
mode for a selected time span, for example, in pause or stop mode. To exit
the screen saver mode, press any key.
[Automatic Standby]: Switch HMP4000 to standby mode when there is no
button press or media play on HMP4000 for 15 minutes.
[Request to Resume Play]: Allow you to select whether to resume video
play from the last stop position.
[Reset Factory Defaults]: Restore factory settings.
Audio
[HDMI Audio Mode]: Select audio output for the HDMI connector.
[Optical output]: Select audio output for the OPTICAL connector
[Lip Sync]: Synchronize audio with video play.