Philips HMP4000 - 6 Easylink

20 EN
6 EasyLink
HMP4000 supports Philips EasyLink which uses the HDMI CEC (Consumer
Electronics Control) protocol. You can use a single remote control to control
EasyLink compliant devices that are connected through HDMI.
1 Through HDMI, connect HMP4000 to a TV compliant with the HDMI CEC
protocol.
2 On the TV, switch on the functions to allow HDMI CEC operations (Consult
the user manual of the TV).
3 On HMP4000, switch on [Easy Link].
• On the Home screen, select [Setup] > [Easy Link]. Select [On].
4 In [Easy Link], you can select the following options:
[One Touch Play]
When you start play on HMP4000, the TV switches to the HDMI input channel
automatically.
[One Touch Standby]
When you switch the TV to the standby mode, HMP4000 switches to the
standby mode automatically.
[AutoPowerOnFromTV]
When you switch to the input channel of HMP4000 on the TV, HMP4000 can
switch on automatically from the standby mode.
Note
• Philips does not guarantee 100% interoperability with all HDMI CEC devices.