Philips HR1368 - Preparing for use; Charging; Light indications; Batteries fully charged

Preparing for use
There are two ways to install the charger:
1 Mount the charger on the wall, close to a socket. (Fig. 2)
2 Place the charger on the worktop.
Charging
Charge the hand blender:
before you use the appliance for the rst time, or
when the blue charging light ashes to indicate that the batteries
are low.
1 Put the adapter in the wall socket.
2 Put the motor unit in the charger. (Fig. 3)
The blue charging light slowly ashes to indicate that the appliance
is charging (Fig. 4).
Note: The adapter feels warm during charging. This is normal.
It takes 4 hours to fully charge the appliance.
Charge the appliance for at least 15 minutes to use it for a light
blending job (soup, puree).
Do not charge the appliance for more than 24 hours.
3 You can place the blender bar in the charger next to the motor
unit. (Fig. 5)
Light indications
Charging
When the appliance is charging, the blue charging light ashes slowly.
Batteries fully charged
When the batteries are fully charged, the charging light lights up blue
continuously.
Batteries low
When the batteries are low, the blue charging light ashes. The lower
the energy level in the batteries, the faster the charging light ashes.
-
-
,
-
-
-
-
-
ENGLISH 9