Philips HR2357 - Assembling the Pasta Maker; Step-by-Step Assembly

10 ENGLISH
Important
Assembling
Follow below assembling steps to install
the pasta maker.
1
Push the mixing chamber into the appliance.
2
Point the mixing paddle to the hole in the main
unit. Insert the mixing paddle all the way into the
main unit.
3
Attach the disc holder onto the appliance.
❶
Disc holder safety switch
❷
Disc holder safety switch lever
Note:
• Check that the safety switch
❶
and safety
switch lever
❷
are set as shown in the
illustration to the right.
1
2
• Make sure to tighten the front panel knobs during assembly.
• Make sure the appliance is not plugged in when assembling the appliance.