Philips HSB4352 - 6 Adjust Settings; General Setup; Switch to Standby Mode

24
[EasyLink]
If this unit is connected to HDMI CEC
compliant TV/devices, all connected devices
can respond to the following commands
simultaneously:
Option Description
[One
Touch
Play]
When you press
, the TV and
this unit are turned on. Disc play
starts if there is a disc in the unit.
[System
Standby]
When you press and hold
, connected HDMI CEC devices
simultaneously switch to standby.
To disable this feature, select
[Decline].
[System
Audio
Control]
When you play audio that is
routed from the connected
devices, this unit switches to
the corresponding audio source
automatically.
To enable this feature, select [On].
Then proceed to [Audio Input
Mapping] to scan and map all the
connected devices.
[Audio
Input
Mapping]
When you map the audio input
correctly, this unit switches to
the audio from the played device
automatically.
Note
You must turn on the HDMI CEC operations on the •
TV/devices before you can enjoy the EasyLink controls.
See the TV/devices manual for details.
Philips does not guarantee 100%
interoperability with all HDMI CEC compliant
devices.
[Display Dim]
Change the brightness level of the display panel
on this unit.
• [100%] – Normal brightness.
• [70%] – Medium brightness.
• [40%] – Dimmest display.
6 Adjust settings
1 Press OPTIONS.
2 Select a setup page.
3 Select an option and then press .
4 Select a setting and then press OK.
To return to the previous menu, press •
.
To exit the menu, press • OPTIONS.
General setup
On [General Setup Page], you can set the
following options:
[Disc Lock]
Set play restriction for specifi c discs. Before you
start, place the disc in the disc compartment
(maximum 40 discs can be locked).
• [Lock] – Restrict access to the
current disc. You need to enter a
password to unlock and play the disc.
• [Unlock] – Play all discs.
Tip
To set or change the password, go to • [Preference
Setup] > [Password].
[OSD Language]
Select the preferred language for on-screen
display.
Switch to standby mode
[Standby Mode]
Set the standby mode.
• [Normal] - power consumption <4W.
• [Low Power] - power consumption
<1W. However, it requires longer time
to power up.
EN