EasyManua.ls Logo

Philips HTS3538 - MP3 player; Create MP3 files

Philips HTS3538
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 EN
3 Select a picture and then press OK to start
the slideshow.
4 Press to stop slideshow.
5 Press again to stop music.
Radio
Listen to FM radio on your home theatre, and
store up to 40 radio stations.
Note
AM and digital radio are not supported.
If no stereo signal is detected, or if fewer than
ve stations are found, you are prompted to
install the radio stations again.
1 Extend the FM antenna at the back of your
home theatre and place it away from the TV
or other sources of radiation.
2 Press RADIO .
» If you have already installed the radio
stations, the last channel that you listened
to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. press
.
3 Use the remote control to listen or to
change radio stations.
Button Action
Numeric
buttons ,
/
Select a preset radio station.
Navigation
buttons
Left/Right: Search for a radio
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation of
radio stations.
Press and hold to erase the
preset radio station.
PROGRAM Manual:
1) Press PROGRAM . 2) Press
/
to select your preset. 3) Press
PROGRAM again to store the
radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
MP3 player
Connect a MP3 player to play audio les.
What you need
An MP3 player.
A 3.5mm stereo audio cable.
1 Using the 3.5mm stereo audio cable, connect
the MP3 player to the MUSIC iLINK
connector on your home theatre.
2 Press SOURCE repeatedly until MUSIC
I-LINK appears on the display panel.
3 Press the buttons on the MP3 player to select
and play audio les.
Create MP3 f les
Use your home theatre to convert audio CDs into
MP3 les.
What you need
An audio disc.
A USB storage device.
1 Connect a USB storage device to your home
theatre.
2 Play your audio CD (CDDA).
3 Press CREATE MP3 .
» A con rmation message is displayed.
4 Select [Yes] , and then press OK .
» The create MP3 screen is displayed. The
right panel contains MP3 settings and the
left panel shows the audio tracks.

Other manuals for Philips HTS3538

Related product manuals