Philips HTS7201 - MP3 Player; Ipod or Iphone

26
MP3 player
ConnectyourMP3playertoplayyouraudioles
or music.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
Play music
1 Connect the MP3 player to the home
theaterasdescribedinthequickstartguide.
2 Press SOURCE repeatedly until MUSIC
I-LINK appears on the display panel.
3 Press the buttons on the MP3 player to
selectandplayaudiolesormusic.
iPod or iPhone
When you connect a Philips dock for iPod/iPhone,
you can use the home theater to play music,
movies and photos from your iPod or iPhone.
What you need
• A Philips dock (Model: Philips DCK3060).
• A yellow composite cable.
Note
•
Charge your iPod/iPhone on the dock while
the home theater is in iPod mode.
Dock your iPod or iPhone
1 Move the slide at the bottom of the dock to
STANDARD, and then connect the dock to
the home theater.
2 Connect the yellow composite cable to the
dock and TV.
3 Switch on the iPod or iPhone, and place it
on the dock.
3 Press the following buttons to listen or to
change radio stations:
Button Action
/ or
Alphanumeric
buttons
Select a preset radio station.
Navigation
buttons (left/
right)
Search for a radio station.
Navigation
buttons (up/
down)
Finetunearadiofrequency.
Press to stop the installation of
radio stations.
BACK
Press and hold to erase the
preset radio station.
OPTIONS
Manual: Press once to access
program mode, and press again
to store the radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
Listen to radio
1 Press SOURCE repeatedly until RADIO
appears on the display panel.
• To listen to a preset station, press
or
.
• To search for a radio station, and then
listen, press Navigation buttons (left/
right).
2 Press +/- (Volume) to change the volume.
EN