Philips HU4805 - Setting the timer; Setting the humidity level; Water level; Refilling reservoir

8
EN
Turning the humidier on
and o
1 Put the plug of the humidier into
the wall outlet.
2 Press the power button to turn on
the humidier (g. g).
» The current humidity level and
fan speed display on the screen.
3 Press the power button to turn o
the humidier.
Note
• The humidier releases very ne invisible
mist, so it is normal that you cannot see
the mist.
• If the water level in the reservoir is
getting very low, the humidier stops
humidifying. The red indicator light rst
starts blinking and then remains on.
4 Using the
humidifier
Humidity indication
The humidier is equipped with a
built-in smart humidity control sensor.
You can set the target humidity level
at 40%RH, 50%RH and 60%RH. The
humidity level of the surrounding air
displays on the center of the control
panel from 20%RH to 95%RH.
Note
• A comfortable humidity level is from
40RH% to 60RH%.
• The accuracy of the humidity indication
is approximately ±10%.
• It takes some time to measure the
humidity level in the room.
Automatic shut-o
The automatic shut-o gives you a
timely warning when the reservoir needs
relling. When the water in the reservoir
starts getting low, a red indicator on
the control panel starts blinking to tell
you that it is time to rell the reservoir
(g. f). It blinks for 30 minutes. After
that, the indicator remains on before the
reservoir is relled with water.
When the reservoir is empty and
needs to be relled, the humidier
automatically shuts o and a red
indicator light turns on. When you
rell the reservoir, the humidier
automatically turns on again.
Note
• In sleep mode, the red indicator does
not blink, it turns on when the water
level is low.