Philips HU4805 - Changing the fan speed

7
EN
English
3 Getting started
Prepare the humidier
1 Place the humidier on a at, stable
surface, about 4 inches (10cm) away
from an inside wall. Make sure the
surface is not sensitive to moisture.
2 Hold by both sides of the upper unit
to lift it up (g. c).
3 Fill the reservoir with approximately
67 . oz/2000ml cold tap water
until water reaches the maximum
water level indication (g. d).
4 Place the upper unit back onto the
reservoir (g. e).
Note
• DO NOT overll the reservoir.
• Always empty the reservoir before
relling with clean, cold tap water. Rinse
the reservoir, wipe clean and dry with a
clean cloth or paper towel. For complete
cleaning instructions, see section ‘Clean
your humidier’.
Controls overview(g. b)
G
Power
button
Turn on or turn o
the humidier.
H Timer button
Set the timer for
the humidier
(1H, 4H, and 8H).
I
Fan speed
button
Adjust the fan
speed
(AUTO, (low),
(normal),
and (high) .
J
Humidity
button
Set the relative
humidity level (40,
50 or 60).
K
Water level
indication
The indicator
blinks when there
is not enough
water in the
reservoir.