Philips HU4813 - Using Your Humidifier; Setting Humidity, Water Levels, and Refilling

8
EN
To deactivate the timer function, press
the timer button repeatedly until the
timer light turns o.
Set the humidity level
Note
• Make sure that the water tank is lled
with water before the humidier can
function (see the chapter 'Get started',
section 'Prepare for humidication').
1 Press the humidity button once
or more times to set the desired
air humidity to 40RH%, 50RH% or
60RH% (g. k).
» The humidity light (40, 50 or 60)
of the humidity level goes on.
» The ambient humidity level
displays on the center of the
control panel.
Tip
• A comfortable humidity level is from
40RH% to 60RH%. You can choose
the preferred humidity level at 40%RH,
50%RH or 60%RH..
Note
• If no preset humidity level is selected,
the humidier will stop working when
the humidity level reaches 50RH% in the
auto mode and 70RH% in other modes.
Water level
When there is not enough water in the
water tank, the appliance will work in
the following ways.
• The water level drops and the
red indicator light starts blinking
(g. e).
• The humidier continues to work for
30 minutes and then stops working,
the red indicator light remains on.
The appliance will resume work when
you rell water into the water tank.
Note
• If the water tank is empty when the
humidier is plugged in and switched
on, the red indicator light blinks for
2 minutes and then remains on before
the water tank is relled with water.
• It is normal to nd some water left in the
tank.
Rell water
Water level can be observed through
the transparent water tank window.
1 Switch o the humidier and unplug
it.
2 Remove the upper unit by holding it
at both sides (g. b).
3 Fill the water tank with cold tap
water until water reaches the
maximum water indication level
(g. c).
Note
• When lling water, do not exceed the
maximum water level, or water might
leak from the drain hole and air inlets.
• Do not shake the water tank when
moving it, or water might leak from the
drain hole and air inlets.
• Do not ll water through the air outlets
on top of the humidier.
4 Place the upper unit back onto the
water tank.