Philips HU4813 - Using Your Humidifier; Humidity Indication and Alerts

6
EN
The healthy air protect lock always
ensures that your humidier does not
work without water in the tank. When
the water tank is empty and needs to be
relled, the healthy air protect lock shuts
o the humidier after 30 minutes and
a red indicator lights up. When you rell
the water tank properly, the humidier is
turned on again.
Note
• In sleep mode, the red indicator does
not blink, it turns on when the water
level is low.
Switch the humidier on
and o
1 Put the plug of the humidier into
the wall socket.
2 Press the power button to switch
on the humidier (g. f).
» The current humidity level and
fan speed display on the screen.
3 Press the power button to switch
o the humidier.
Note
• If the water level in the tank is
getting very low, the humidier stops
humidifying. The red indicator light rst
starts blinking and then remains on.
• The humidier releases very ne invisible
mist, so it is normal that you cannot see
the mist.
4 Using the
humidifier
Understand the humidity
indication
The humidier is equipped with a built-
in humidity sensor. You can set the
target humidity level at 40%RH, 50%RH
and 60%RH. The ambient humidity level
displays on the center of the control
panel from 20%RH to 95%RH.
Note
• A comfortable humidity level is from
40RH% to 60RH%.
• The accuracy of the humidity indication
is approximately ±10%.
• It takes some time to measure the
humidity level in the room.
Understand the healthy air
protect alert and lock
The healthy air protect alert gives you
a timely warning when the water tank
needs relling. When the water in the
tank starts getting low, a red indicator
on the control panel starts blinking to tell
you that it is time to rell the tank (g. e).
It blinks for 30 minutes. After that, the
indicator remains on before the water
tank is relled with water.